#3
Floyd rose is a direct swap. However, you might need a light 1mm-2mm sanding on the bottom hand side of the route. Get the Floyd and see, its not hard to do a quick sanding if you need it.
For those who care.
Current Gear
Cort Zenox Z42
Flextone II
Charvel USA So-Cal
Farida M2 Parlour Acoustic
Admira Hand-built Spanish Acoustic
Blackstar HT-5H
Line 6 M13
#4
Given the Edge III is a lo pro, I would say you could only swap for a Lo Pro OFR or Schaller w/ short lock bolts, but it's been awhile since I've had one to measure how much clearance you have.
#6
There was a thread 5 or so months back with a guy who replaced his edge 3 with a floyd rose. Everything fit near perfectly, except for a little rubbing on the control side of the routing. A quick sand and it was done. No need to get a low profile floyd.
For those who care.
Current Gear
Cort Zenox Z42
Flextone II
Charvel USA So-Cal
Farida M2 Parlour Acoustic
Admira Hand-built Spanish Acoustic
Blackstar HT-5H
Line 6 M13
#8
Try and save up for one. No point in 'upgrading' to another piece of crap trem. Trust me, you will no regret it.
For those who care.
Current Gear
Cort Zenox Z42
Flextone II
Charvel USA So-Cal
Farida M2 Parlour Acoustic
Admira Hand-built Spanish Acoustic
Blackstar HT-5H
Line 6 M13
#9
yeah that makes sense. anyone who has replaced an Edge III with an OFR please post pics.