#1
Good day sirs. I have an LP custom but its arm is curved upward, meaning, if you press the strings to the fret at both ends, you can see a 2 milimeter gap between the string and the fretwire in the middle section of the arm. How can I solve this? Thanks
#2
you're talking about the neck. you can adjust the truss rod. if you dont know how, google it or take it to a luthier or tech.
Ibanez RG321MH (Air Classic/Tone Zone)
Fernandes Telecaster (Twang King/stock bridge pickup)
Blackstar HT-20 (Scumback 55 speaker/ Tung Sol tubes)
TC Electronic Nova Repeater
Lava Cables Clear Connect, Soar and Mini ELC
#5
tighten of course.
Ibanez RG321MH (Air Classic/Tone Zone)
Fernandes Telecaster (Twang King/stock bridge pickup)
Blackstar HT-20 (Scumback 55 speaker/ Tung Sol tubes)
TC Electronic Nova Repeater
Lava Cables Clear Connect, Soar and Mini ELC
#6
you want a small gap... 0.4mm
Support your local luthier!

Timpson Guitars and TDM Pickups rock ;D

I make guitars and pickups. I also make sh*t that'll blow you the f*k up as well as things that will rebuild you - I have the technology