#1
I have a Epiphone SG special, and iv'e been looking at it lately and it looks too plain. How would i go about attaching a pickguard too it? Any links for a guide? Thanks.
#2
I'd start with buying a pickguard. It's realy pretty self explanitory from there.
Quote by dcdossett65
Life is too short to worry about this crap.

Who.

Cares.
#3
I do...bought one off ebay. Just need to know if i could just screw it in? I dont know what im doing .
#4
Well, I'm assuming there aren't already screw holes for the pickguard, So here's what I'd do:

Take off the strings, and set the pickguard in place. Then I'd take a sharpy or somthing and make a small mark where the screws should be. After that I would get a drill bit slightly smaller than the skrews and drill the holes (make sure you don't drill to deep, as the screws are very short anyway). then I'd just skrew it on and put on a new set of strings.

Also...don't worry so much about sounding 'stupid', you can't learn without asking questions and people will understand that.
Quote by dcdossett65
Life is too short to worry about this crap.

Who.

Cares.