#1
(Invalid img)
The power section with the components that stretch all the way over the board is going to be made smaller if the rest is right.

The BYOC schematic is wrong for a part, so I used the Tonepad schematic for everything but the clipping switch mod, and the clipping switch mod from the BYOC Mouse schematic on page 17 of the instructions to the project.
Downloads for schematics:
Clipping switch mod (use ONLY to check the switch, a lot of the rest is messed up): http://buildyourownclone.com/mouse.html
Rest of the schematic: http://www.tonepad.com/getFileInfo.asp?id=89

I am building this in a couple of days so feedback would be really appreciated, by the way this is my first pedal build and I made the layout myself.

As to the switch wire labeling: I put it in an X-X format. The first X stands for the switch's pole number (as in the Mouse schematic, pole 1 is at the bottom near the OpAmp's output, and pole 2 is near the distortion pot lug wires 2 and 3), and the second X stands for the throw number. So for example for the second throw's third pole, it would say out to the side "2-3."

If anyone could check and see if I made any errors, I would greatly appreciate it. And trust me, I'll show you with a lot of pics once I build it!
Gear:
Schecter Hellraiser Deluxe
Boss DS-1
Crate GTD65

GAS List:
Mesa Boogie Dual Rectifier Roadster
#2
No offense man but that is a terrible layout. Its huge and does not utilize space well.

For your first pedal I would use a verified compact layout. Its just one less thing to screw up.

Also you don't need vero for those diodes. You can just wire them PTP to your switch.
#3
I know I could much easier use an already verified layout, but I couldn't find any vero layouts online, so I decided to make my own. Also space is not much of an issue, this is really only for personal use right now, the point is I want it to work, not necessarily look pretty. And yeah I know the layout sucks, but I just need it to work. If you or someone else can make a better layout for me, then I would appreciate that, but for now this is all I have.
Gear:
Schecter Hellraiser Deluxe
Boss DS-1
Crate GTD65

GAS List:
Mesa Boogie Dual Rectifier Roadster
#5
^ Yeah, but it's a PCB layout, not vero.
Gear:
Schecter Hellraiser Deluxe
Boss DS-1
Crate GTD65

GAS List:
Mesa Boogie Dual Rectifier Roadster
#6
Quote by asfastasdark
^ Yeah, but it's a PCB layout, not vero.


with a bit of creativity, you can transform PCB layouts into vero layouts

(I personally rebuild the thing in EAGLE than keep moving around parts so common legs are aligned horizontally where possible)