#1
Hey guys, I need some help to get the most out of my amp/effects setup.

I had a Gibson LP Studio going into a Digitech DF-7 Distortion factory, which goes to a Crybaby, and out to my Kustom Solo 16 amp.

The problem is that when I use the Wah, it goes from distortiony (down) to really high pitched-hurt-your-ears loud noise. Is there any way i can modify my setup to stop this?

Im using:

Amp
-----
Clean, low mid and high each set at halfway.

Distortion Pedal
--------------------
Level, mid-freq, gain, low, mid, and high all at 3/4 full
Using #7, Fuzz. (Electro-Harmonix Big Muff emulator)

My amp does have distortion built in, but it sounds pretty bad.

Thanks.
#2
Put the wah first.
Alvarez dreadnought
Gibson SG
EC-1000
Homemade Strat (seymour duncan classic stack p/ups)
Vox Tonelab (original desktop model) with full board footswitch
Vox AD50
Avatar V30 4x12 cab
#3
maybe you could put the wah before the distortion pedal.
this might change the hurt your ears loud screech noise.
Guitars:
'13 MIM Fender Strat - '05 Epi G-400
Amps:
Fender HRD - VHT Special 6 Ultra -
Jet City JCA20H - Mesa Rectifier 2x12
Pedulz:
Slash Wah - OCD v1.7 - Red Llama MKII -
Big Muff Pi - Carbon Copy - Phase 90 - Ditto Looper
#4
I always thought that it lessened the sounds difference of the wah, but I guess its not that bad after all. Still gets a solid sound out of it. Thanks guys.
#5
Quote by IanPRom
I always thought that it lessened the sounds difference of the wah, but I guess its not that bad after all. Still gets a solid sound out of it. Thanks guys.

Well, it does, but when the sound difference is so great that the high sweep hurts your ears, lessening the effect might be a good idea.
Alvarez dreadnought
Gibson SG
EC-1000
Homemade Strat (seymour duncan classic stack p/ups)
Vox Tonelab (original desktop model) with full board footswitch
Vox AD50
Avatar V30 4x12 cab