here this is what i came up with

The switches are wired up so that the coil split goes from humbucker to south coil.
If you would rather have it humbucker north coil: the North coil start goes straight to the pickup switch (the one that switches between both pickups ) The North coil and South Coil finish go to the middle lug of the mini switch and the south coil start goes to the bottom lug of the switch and then to ground.
Heres a diagram:

Also remember to ground all wires which need to be grounded, to the back of the volume pot, then have a wire going from the back of the volume pot (on the same solder as the other grounds) which goes to the bridge or the spings claw (depending on what bridge you have)

Happy Days
thank you. that seems relatively easy. i need to learn this stuff better.